Here is another new product.
We installed a new ball bearing turbo on our GN and came up with a kit
for the cooling lines. Everything is cut to size for an easy
install and will fit with a turbo shield. Hooks to your intake
coolant pipe using the outlets that normally runs coolant to the
throttle body which is not needed. Braided hoses have the hose
ends already installed. The connections to the coolant pipe on the
intake has regular hose clamps that have an aluminum anodized cover over
This will not work if
you have eliminated your intake coolant pipe.
Turbos use a 14mm opening for the banjo fittings we use.
The standard kit includes the following:
- 14mm Banjo fittings with -6 male ends
- 6 female hose ends already installed
2 -6 braided hose cut to proper
2 - hose end covers
for the connections to coolant pipe
THIS IS A SPECIAL ORDER ITEM THAT USUALLY SHIPS WITHIN ONE WEEK OF