WINDSHIELD WASHER MOTOR COVER

INSTALLATION INSTRUCTIONS

This installation should take no longer than 10 minutes!  The only tool you will need to install the cover would be a 10mm socket and a 10mm box wrench.  I used a deep socket with a 1/4" drive ratchet to install the longer bolts  The wiper motor is located on the driver's side of the firewall.  Remove the top two existing bolts that hold the motor to the firewall mount.  You will be replacing these two bolts with the included longer bolts included in the hardware kit.  Once this is completed the cover slips over the newly installed longer bolts.  Using the supplied flat washers and nuts, secure the cover.

Parts Included

1 - Windshield Wiper Motor Cover

2 - 6mm x 30mm hex head flange bolts

2 - 6mm hex nuts

2 - 6mm flat washers